Common faults and inverter approach
Project |
Common Faults |
Approach |
1 |
Then turn off |
① confirm input DC voltage is within the normal range. (Eg: 24V1000W inverter input DC voltage range of 21VDC-28VDC) |
2 |
Now with load carrying capacity shut down or with poor |
① confirm input DC voltage is correct. ② confirm whether the load capacity of the normal range. |
3 |
No shutdown |
① confirm input DC voltage is connected correctly. ② boot method is correct: If the boot you press the buttons for too long or too short will not boot. ③ the correct approach is to press the start button for 3 seconds, then release the buzzer rang. |
4 |
No shutdown |
① ② shutdown method shuts down correctly when pressing the off button for approximately 3-5 seconds, rather than click on the relevant. |
Notes |
① before using the inverter, please read the instructions ② wiring, strictly in accordance with the instructions in the connection process and wiring standards, and the line after the check again, then boot using the confirmation. ③ long with load, the machine cabinet heating and hot air blowing is normal. ④ When installing the attention to ventilation and cooling, machine vents to maintain smooth, clean, dust-proof. |
Special warning: the machine with a set work, does not allow hot-swappable load or repeated switching machine inverter. In particular, such as with a compressor type load (motors, refrigerators, air conditioners, etc.), OR ELSE! |